BioLife Solutions CryoStor CS10 细胞冻存液预混10% DMSO，适用于冻存多种类型细胞。

品牌：BioLife Solutions

货号：PART No. 210102

容积：VOL. 100mL

型号：CryoStor CS10

BioLife Solutions CryoStor CS10细胞DMSO冻存液210102订购信息

英文名：BioLife Solutions CryoStor CS10 Freeze Media

中文名：BioLife Solutions CryoStor CS10 细胞DMSO冻存液

BioLIfe Solutions CryoStor CS10细胞DMSO冻存液产品系列

各种规格的BioLIfe Solutions CryoStor 细胞DMSO冻存液

BioLife Solutions CryoStor CS10细胞DMSO冻存液210102 代理销售欢迎您致电 华雅再生医学旗舰公司：红荣微再（上海）生物工程技术有限公司  ：152 1681 4001。红荣微再-客服: 316 808 6348  经销商专员

BioLife Solutions CryoStor CS10 Freeze Media 使用与冻存方法

CryoStor® Usage and Cryopreservation Protocol

细胞准备

1) Place cells to be cryopreserved into suspension (mechanical or enzymatic dissociation)

2) Centrifuge cells to obtain cell pellet

3) Remove supernatant - Note: Remove as much culture media as possible, to reduce dilution of CryoStor® solution.

加CryoStor冻存液

4) ISOLATION: Add cold (2-8°C) CryoStor®

a. Cell concentrations: 0.5-10 x 10⁶

 cells/ml for routine cell culture protocols (higher [cell] possible).

b. DMSO is pre-mixed in CryoStor® - no additives are necessary.

5) PRE-FREEZE: Incubate cell suspension at 2-8°C for approximay 10 minutes

6) NUCLEATION: Freeze samples at -70°C (many protocols utlilize -70°C and -80°C interchangeably)

a. Use a controlled rate freeze (-1°C/min) or similar protocol for most mammalian cell systems.

b. The freezing device or isopropanol container should be pre-cooled to 2-8°C.

c. Ice nucleation within the sample (seeding) should be initiated at approximay -5°C using either a liquid nitrogen burst program setting on a controlled rate freezer or mechanical agitation (flick or tap) of the cryovial/sample container after approximay15-20 min. at -70°C.

d. Freeze time (-70°C) using isopropanol containers is recommended to be 3-4 hours.

BioLife Solutions 储存

7) STORAGE: Place samples into storage

a. Store samples at liquid nitrogen temperatures (below -130°C).

b. Sample storage at -80°C is only recommended for short-term storage (weeks to months).

细胞复苏解冻

8) THAWING: Thaw samples quickly in a 37°C water bath

a. Sample thawing should be conducted with gentle swirling of sample until all visible ice has melted. Approximate thaw time for a 1 ml sample in a cryovial is approximay 3 minutes.

b. DO NOT allow sample to warm above chilled temperatures (0-10°C). Cryovials should be cool to the touch when removed from bath.

Passive thaw is not recommended.

9) Dilute cell/CryoStor® mixture immediay with culture media

a. Dilution procedure can be preformed in a single step.

b. The dilution media should be between 20°C and 37°C.

c. A dilution ratio of 1:10 (sample to media) or greater is recommended.

10) Plate cells in appropriate configuration

11) Place cells into culture conditions or utilize immediay

12) Viability assessment 24-hours post-thaw*

BioLife Solutions Note: To obtain an accurate measure of cell viability following cryopreservation, assessment should be performed 24 hours post-thaw and compared to non-frozen controls.

*Sample assessment immediay post-thaw with membrane integrity indicators, such as Trypan Blue, for comparative analysis of sample cell yield and viability often results in significant overestimates of cell survival.

Live/Dead fluorescent assays or metabolic assays (MTT or alamarBlue®) are recommended for more accurate viability assessment.

Visual inspection of adherent cells and cells “floating” in the media is also recommended.

BioLife Solutions CryoStor CS10细胞DMSO冻存液210102 代理销售欢迎您致电 华雅再生医学旗舰公司：红荣微再（上海）生物工程技术有限公司  ：152 1681 4001。红荣微再-客服: 316 808 6348  经销商专员